Dell 100-Mbps manual Check the monitor documentation to make

Table A-1. System Setup Categories (continued)

Category	Function
Power Management	With the Power Management category
	enabled, DPMS monitors and most EIDE
	drives automatically switch into low-power
	mode during periods of system inactivity.
	CAUTION: Before enabling this feature,
	check the monitor documentation to make
	sure the system has a DPMS-compliant
	monitor. Otherwise, there is a risk of dam-
	aging the monitor.
	NOTE: Not all EIDE hard-disk drives support
	this feature. Enabling this feature for drives
	that do not support it may cause the EIDE
	drive to become inoperable until the system is
	restarted and the Power Management category
	is disabled.
Sound	Enables (On [default]) or disables (Off) the
	audio controller.
NIC	Enables (On) or disables (Off) the network
	interface controller.
Mouse	Enables or disables the built-in PS/2-
	compatible mouse port.
Serial Port 1	Configures system’s built-in serial ports.
Serial Port 2
Parallel Port	Configures system’s built-in parallel port. The
	port’s I/O address may be set to 278H, 3BCH,
	or 378H. Otherwise, the port may be dis-
	abled.
Parallel Modes	Controls whether system’s built-in parallel port
	acts as an AT-compatible (unidirectional) or
	PS/2-compatible (bidirectional) port.
IDE Hard Disk	Enables system’s built-in EIDE hard-disk drive
	interface.
Diskette	Enables system’s built-in diskette controller.
USB	Enables (On) or disables (Off [default]) the
	USB connectors.
	NOTE: This category appears only on GXpro
	systems containing the 10/100-Mbps Ethernet
	NIC.
Speaker	Enables on-board speaker.

System Setup Program A-5