Appendix 93
14 Attach the computer stand (see page 19).
NOTICE: To connect a network cable, first plug the cable into the network
wall jack and then plug it into the computer.
15 Connect your computer and devices to electrical outlets, and turn
them on.
Turning on your computer with the PSWD jumper installed reenables
the password feature.
Replacing the Battery CAUTION: Before you begin any of the procedures in this section,
follow the safety instructions on page 7.
A coin-cell battery maintains computer configuration, date, and time
information. The battery can last several years.
If you have to repeatedly reset time and date information after turning on
the computer, replace the battery.
CAUTION: A new battery can explode if it is incorrectly installed.
Replace the 3-V CR2032 battery only with the same or equivalent
type recommended by the manufacturer. Discard used batteries
according to the manufacturer’s instructions.
1Record all the screens in the system setup program (see page90) so
that you can restore the correct settings in step9.
2Remove the computer stand (see page 19).
3Open the computer cover (see page 74).
4Locate the battery socket BATTERY (see page77).
5Remove the battery by carefully prying it out of its socket with your
fingers or with a blunt, nonconducting object such as a plastic
screwdriver.