Action
CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. Before performing any procedure, see your Product Information Guide for complete information about safety precautions, working inside the computer and protecting against electrostatic discharge.
1Enter the System Setup program and verify that the diskette drive is configured correctly. See "Using the System Setup Program" on page 37.
2Open or remove the bezel. See "Front Bezel" on page 53.
3Run the appropriate online diagnostic test. See "Using Server Administrator Diagnostics" on page 131.
4Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
5Open the system. See "Opening and Closing the System" on page 54.
6Ensure that the diskette drive interface cable is securely connected to the diskette drive and the system board.
7Ensure that a power cable is properly connected to the drive.
8Close the system. See "Opening and Closing the System" on page 54.
9Reconnect the system to the electrical outlet, and turn on the system and attached peripherals.
10Run the appropriate online diagnostic test to see whether the diskette drive works correctly.
11Turn off the system and attached peripherals, and disconnect the system from its electrical outlet.
12Open the system. See "Opening and Closing the System" on page 54.
13Remove all expansion cards installed in the system. See "Removing an Expansion Card" on page 78.
14Close the system. See "Opening and Closing the System" on page 54.
15Reconnect the system to the electrical outlet, and turn on the system and attached peripherals.
16Run the appropriate online diagnostic test to see whether the diskette drive works correctly.
If the tests run successfully, an expansion card may be conflicting with the diskette drive logic, or an expansion card may be faulty. Continue to the next step.
If the tests fail, see "Getting Help" on page 147.
17Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
18Open the system. See "Opening and Closing the System" on page 54.
19Reinstall one of the expansion cards you removed in step 13. See "Installing an Expansion Card" on page 76.
20Close the system. See "Opening and Closing the System" on page 54.
21Reconnect the system to the electrical outlet, and turn on the system and attached peripherals.
22Run the appropriate online diagnostic test to see whether the diskette drive works correctly.
122
Troubleshooting Your System
