Dell 2950 E1410, E1414 CPU # Thermtrip, E1418 CPU # Presence, E141C CPU Mismatch, E1421 CPU Init

Table 1-6. LCD Status Messages (continued)

Code	Text	Causes	Corrective Actions
E1410	CPU # IERR	Specified microprocessor is	See your system’s Information
		reporting an internal error.	Update Tech Sheet located on
			support.dell.com for the most
			current system information. If
			problem persists, see "Getting
			Help" on page 147.
E1414	CPU # Thermtrip	Specified microprocessor is out of	See "Troubleshooting System
		acceptable temperature range and	Cooling Problems" on page 119.
		has halted operation.	If the problem persists, ensure
			that the microprocessor heat
			sinks are properly installed. See
			"Troubleshooting the
			Microprocessors" on page 128.
			NOTE: The LCD continues to
			display this message until the
			system’s power cord is
			disconnected and reconnected to
			the AC power source, or the SEL is
			cleared using either Server
			Assistant or the BMC Management
			Utility. See the Dell OpenManage
			Baseboard Management
			Controller User’s Guide for
			information about these utilities.
E1418	CPU # Presence	Specified processor is missing or	See "Troubleshooting the
		bad, and the system is in an	Microprocessors" on page 128.
		unsupported configuration.

E141C	CPU Mismatch	Processors are in a configuration
		unsupported by Dell.

Ensure that your processors match and conform to the type described in the Microprocessor Technical Specifications outlined in your system’s Getting Started Guide.

E141F	CPU Protocol	The system BIOS has reported a	See "Getting Help" on page 147.
		processor protocol error.
E1420	CPU Bus PERR	The system BIOS has reported a	See "Getting Help" on page 147.
		processor bus parity error.
E1421	CPU Init	The system BIOS has reported a	See "Getting Help" on page 147.
		processor initialization error.

About Your System

21