Installing System Components 99
Figure 3-31. Replacing the Left Riser Board
Installing the Left Riser Board CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the
components inside the system. See your Product Information Guide for complete information about safety
precautions, working inside the computer, and protecting against electrostatic discharge.
1
Place the riser board in the expansion-card cage so that the six securing tabs are fully inserted in the six
securing slots on the riser board. See Figure3-31.
2
Slide the riser board toward the expansion card openings until you feel the riser-board release pin snap
into place.
3
Replace the expansion-card cage. See "Replacing the Expansion-Card Cage" on page79.
4
Install all expansion cards in the expansion-card slots. See "Installing an Expansion Card" on page76.
5
Close the system. See "Closing the System" on page55.
1 riser release pin 2 expansion-card rails 3 expansion-card cage
4 riser securing tabs (6) 5 riser securing slots (6)
2
4
1
3
5
Book.book Page 99 Friday, February 3, 2006 11:09 AM