Installing a Media Card Reader
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer’s electronic components. You can do so by touching an unpainted metal surface on the computer chassis.
1Follow the procedures in "Before You Begin" on page 53.
2Remove the drive panel (see page 70).
3Remove the Media Card Reader and bracket from its packaging.
4Insert three shoulder screws into the sides of the Media Card Reader and tighten them.
5Gently slide the drive (which should not yet be connected to the FlexBay cable) into place until you hear a click or feel the drive securely installed.
6Connect the USB cable on the back of the Media Card Reader to the front panel USB connector on the system board (see page 61).
7Connect the FlexBay USB cable to the back of the Media Card Reader.
8Replace the computer cover (see page 84).
DVD Drive
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.
Removing and Installing Parts
81