Dell 4300 manual Replacing the AGP Card, 2H930bk1.book Page 76 Tuesday, November 20, 2001 502 PM

2H930bk1.book Page 76 Tuesday, November 20, 2001 5:02 PM

w w w . d e l l . c o m s u p p o r t . d e l l . c o m

NOTICE: To connect a network cable, first plug the cable in to the network wall jack and then plug it in to the computer.

11Right-click the My Computer icon and then click Properties.

12Click the General tab.

13To verify that the memory is installed correctly, check the amount of memory (RAM) listed.

Replacing the AGP Card

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions listed in “When Working Inside Your Computer” on page 12.

1Shut down the computer (see page 20).

2Turn off any attached devices and disconnect them from their electrical outlets.

NOTICE: To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network wall jack.

3Disconnect the computer power cable from the wall outlet, and then press the power button to ground the system board.

4Open the computer cover (see page 65).

5Press the card clip lever on the side of the AGP card to release the card from the slot connector, and remove the card.

AGP card

card clip lever

AGP card clip

slot connector back of computer

76

Adding Parts