Dell 4300 manual Close the computer cover see page

2H930bk1.book Page 80 Tuesday, November 20, 2001 5:02 PM

w w w . d e l l . c o m s u p p o r t . d e l l . c o m

HINT: Your computer uses cable-select drive cables. This means that the device connected to the end connector of the drive cable is the master device and the device connected to the middle connector is the slave device. Be sure that the jumper setting on the new device is set for "cable select" (see the documentation that came with the drive for information).

11Locate the extra connector on the drive cable that is attached to your first hard drive and attach the connector to the second hard drive.

power cable

second hard-drive cable (secondary drive)

first hard-drive cable (primary boot drive)

12Close the computer cover (see page 87).

13Connect your computer and devices to their electrical outlets, and turn them on.

NOTICE: To connect a network cable, first plug the cable in to the network wall jack and then plug it in to the computer.

14See the documentation that came with the drive for instructions on installing any software required for drive operation.

80

Adding Parts