Dell 4300 manual Closing the Computer Cover, DELL CONFIDENTIAL - PRELIMINARY 11/20/01

2H930bk1.book Page 87 Tuesday, November 20, 2001 5:02 PM

13See the documentation that came with the drive for instructions on connecting a drive cable to the drive.

power cable

drive cable

14Connect your computer and devices to their electrical outlets, and turn them on.

NOTICE: To connect a network cable, first plug the cable in to the network wall jack and then plug it in to the computer.

15Install any drivers required for the drive as described in the drive documentation.

Closing the Computer Cover

1Ensure that all cables are connected, and fold cables out of the way.

2Ensure that no tools or extra parts are left inside the computer.

3Pivot the cover down and ensure that the release buttons click into place.

NOTICE: To connect a network cable, first plug the cable in to the network wall jack and then plug it in to the computer.

4Connect your computer and devices to their electrical outlets, and turn them on.

HINT: Your computer uses cable-select drive cables. This means that the device connected to the end connector of the drive cable is the master device and the device connected to the middle connector is the slave device. Be sure the jumper setting on the new device is set for “cable select” (see the documentation that came with the drive for information).

DELL CONFIDENTIAL – PRELIMINARY 11/20/01

Adding Parts

87