Disk and File System Management3-13
Although you can convert a mirror into a regular volume, you cannot set the
snapmirrored option to on to convert a regular volume into a mirror. To start using a
volume as a mirror, follow the instructions in Chapter 16, Data Replication Using
SnapMirror, to mirror data to the volume.
&$87,21$IWHU\RXFRQYHUWDPLUURULQWRDUHJXODUYROXPHWKHILOHUVWRSV
XVLQJLWIRUGDWDUHSOLFDWLRQ,I\RXZDQWWRXVHWKHYROXPHDVDPLUURU
DJDLQ\RXPXVWWDNHWKHYROXPHRIIOLQHDQGIROORZWKHLQVWUXFWLRQVLQ
&KDSWHU´'DWD5HSOLFDWLRQ8VLQJ6QDS0LUURUµWRUHVWDUWWKHSURFHVVRI
UHSOLFDWLQJGDWDLQWRWKHYROXPH
0DNLQJD9ROXPH,QDFWLYH
To remove a volume from active use upon next reboot, enter
YRORIIOLQHYROXPH
5HDFWLYDWLQJDQ2IIOLQH9ROXPH
To reactivate an off-line volume, enter
YRORQOLQHYROXPH
$GGLQJD)RUHLJQ9ROXPH
To add a foreign volume, that is, a volume that was previously installed on another
filer, you move the disks that contain the volume from the old filer to the destination
filer.
To add a foreign volume, perform the following steps:
1. Follow the instructions in the hardware guide to remove the disks from the old
filer.
2. Turn off the destination filer and install the disks in the destination filers Power-
Vault 700N storage system.
3. Turn on and boot the destination filer.
Results: When the destination filer boots, it places the foreign volume off-line. If
the foreign volume has the same name as an existing volume on the filer, the filer
renames it volume_name(1), where volume_name is the original name of the
volume.
CAUTION: If the foreign volume is incomplete, repeat Steps 1 and 2 to add
the missing disks. Do not try to add missing disks while onlinedoing so
will cause them to become hot spare disks.