13-2 Dell PowerVault 720N, 740N, and 760N System Administrator and Command Reference Guide

:KHQ<RX'R1RW5HFRYHU'DWD)URP7DSH

Recover a deleted file from tape only if you cannot recover the deleted file from any
snapshot on the filer. If the file is in a snapshot, copying the file to the active file sys-
tem is faster than recovering the file from tape.

'LIIHUHQW0HWKRGVIRU5HFRYHULQJ'DWD

The filer supports these methods for recovering data that was backed up by the filers
dump command:
Using the restore command on the filer to restore the file from a local or
remote tape drive. If you use a remote tape drive, the host for the tape drive
must support the rmt protocol.
Using the UNIX ufsrestore command on a client that supports the SunOS
5.x/Solaris 2.x ufsdump format.
&$87,218VHWKH6RODULVufsrestoreFRPPDQGRQO\LI\RXUILOHUUXQV1)6
H[FOXVLYHO\,I\RXUILOHUUXQVWKH&,)6SURWRFROGRQRWXVHWKH6RODULV
ufsrestoreFRPPDQG'RLQJVRUHVXOWVLQGDWDORVV

:KDW'DWD&DQQRW%H5HFRYHUHG

The restore command cannot recover data that was backed up by commands
issued on other systems. For example, do not try to use the filers restore com-
mand to recover a tape file created by the Solaris ufsdump command.

81,;),OH3HUPLVVLRQVDQG:LQGRZV17$&/V

A file recovered by the restore command has the same UNIX file permissions and
Windows NT ACLs as it did when it was backed up. If you restore a file that has only
UNIX file permissions to an NTFS qtree or volume, the file has no Windows NT ACLs.
The filer uses only the UNIX file permissions on this file until you create Windows NT
ACLs on it.

6FRSHRI7KLV&KDSWHU

This chapter describes how to use the filers restore command for data recovery. It
does not describe how to use data recovery commands or programs on other sys-
tems. Refer to the documentation accompanying the other systems for information
about their data recovery commands or programs.
7KHUHVWRUH&RPPDQG6\QWD[

7KHUHVWRUH&RPPDQG6\QWD[

The syntax for the restore command is as follows:
restore [
function_key
] [
options
] [
arguments
] [
subtree
]