A-66 Dell PowerVault 720N, 740N, and 760N System Administrator and Command Reference Guide
nfs.v3.enable
When enabled, the NFS server supports NFS version 3. By default,
the feature is enabled; it can be disabled if there is a problem with
some client when using NFS version 3, and that client cannot be
configured to use NFS version 2.
nfs.webnfs.enable
When enabled, the NFS server supports WebNFS lookups. By
default, WebNFS lookups are disabled.
nfs.webnfs.rootdir
Specifies the WebNFS rootdir. Once the rootdir is set, WebNFS cli-
ents can issue lookups relative to the rootdir using the public
filehandle.
nfs.webnfs.rootdir.set
After specifying the rootdir, this option needs to be enabled for the
rootdir setting to take effect. Disabling this option disables the
existing rootdir setting.
nis.domainname
Sets the NIS domain to the specified domainname.
nis.enable Enables NIS client on the filer. The NIS domain must be set prior to
enabling NIS.
raid.timeout
Sets the time in hours, as a number greater than or equal to 1, that
the system will run after a single disk failure has caused the system
to go into degraded mode. The default is 24. If the raid.timeout
option is specified after the system is already in degraded mode,
the timeout is set to the value specified and the timeout restarted.
raid.reconstruct_speed
Specifies the speed at which the RAID reconstruction should occur
ranging from the slowest speed 1 to the fastest speed possible 10.
The RAID reconstruction process is given more cpu time as the
speed is increased, so increasing the speed of the reconstruction
will take away cpu time for network operations. The default speed
is 4, which is roughly 40% of the cpu time, though more time may
be used if there is idle time available.
raid.scrub.enable
Enables/disables the RAID scrub feature (see disk). By default, it is
enabled. This option only affects the scrubbing process that gets
started from cron. For user requested scrubs, this option is ignored.
rsh.enable Enables the RSH server on the filer.
snmp.enable
Enables the SNMP server on the filer.
options