17-2 Dell PowerVault 720N, 740N, and 760N System Administrator and Command Reference Guide
Determining how much space on each disk is available to the filer. Refer to
Understanding Usable Space on Each Disk in Chapter 3 for more information
about disk capacity.
Determining the status of the disk operations, such as RAID scrubbing, recon-
struction, parity verification, adding a hot spare, and disk failure.
You can obtain the information displayed by sysconfig -r from SNMP, using the
Dell custom MIB. For information about SNMP, see Using SNMP in Chapter 4 .

'LVSOD\LQJ7DSH'ULYH,QIRUPDWLRQ8VLQJV\VFRQILJW

The sysconfig -t command displays device and configuration information for
each tape drive on the system. Use this command to determine the capacity of the
tape drive and the device name before you use the dump and restore commands.

'LVSOD\LQJ2YHUDOO)LOHU,QIRUPDWLRQ8VLQJV\VFRQILJY

The sysconfig -v command displays the systems RAM size, NVRAM size, and
information about devices in all expansion slots. This information varies according to
the devices on the filer. You can specify a slot number to display information about a
particular slot. Slot numbers start at 0, where slot 0 is the system board.

'LVSOD\LQJ2YHUDOO)LOHU,QIRUPDWLRQ8VLQJV\VFRQILJ

If you enter sysconfig without any options, information similar to what you get
with sysconfig -v is displayed, but the information is abbreviated. When you
report a problem to Dell, provide the information displayed by sysconfig -v. This
information is useful for diagnosing system problems.
'LVSOD\LQJ9ROXPH,QIRUPDWLRQ

8VHWKH9ROVWDWXV&RPPDQG

The vol status command displays information about a volumess configuration.
The types of information displayed depend on the command options. When you spec-
ify a volume, the information for that volume is displayed; when you do not specify a
volume, the status of all volumes in the filer is displayed.

'LVSOD\LQJ9ROXPH6WDWH,QIRUPDWLRQ:LWK9RO6WDWXV

With no options, the vol status command displays a one-line synopsis of volume
states. This includes the volume name, whether it is on-line or off-line, and other
states, for example, partial, degraded, and so on.

'LVSOD\LQJ'LVN,QIRUPDWLRQ8VLQJ9ROVWDWXVG

The vol status -d command displays information about disks. The disk informa-
tion is the same as the information from the sysconfig -d command.