Troubleshooting18-15
:LQGRZV$FFHVV3UREOHPV

.LQGVRI$FFHVV3UREOHPV

This section describes preliminary troubleshooting steps, then describes how to trou-
bleshoot the following problems:
Filer cant register with the Windows NT domain.
Incorrect password or unknown username.
Users cant map a drive.

3UHOLPLQDU\7URXEOHVKRRWLQJ6WHSV

Complete the following steps to begin to troubleshoot Windows problems:
1. Make sure that the filer is licensed for CIFS by entering the license command
at the filer prompt.
If the following message appears
&,)6QRWOLFHQVHG
or if a message with protocols other than CIFS appears but CIFS is absent, you
must get a license for CIFS.
NOTE: For information about how to get a license, contact Dell technical support,
as described in Getting Technical Assistance.
2. If you are authenticating through a Windows NT domain, make sure that the filer
has an account in the domain.
NOTE: You can verify that the filer is registered with a domain controller by using
the cifs testdc command.
3. Make sure that CIFS service has been properly configured with the cifs
setup command.

)LOHU&DQ·W5HJLVWHU:LWKWKH:LQGRZV17'RPDLQ

If you are using WINS, use the table Using Wins to troubleshoot the problem. If
you are not using WINS, use the table Not Using WINS.

8VLQJ:,16

Use Table 18-1 if you are using WINS.