15-8 Dell PowerVault 720N, 740N, and 760N System Administrator and Command Reference Guide
that performs the local copying. The filer cannot support these two additional volume
copy operations because three operations are already in progress.

3RVVLEOH(UURUV

If your filer does not meet a requirement described in Requirements and Recom-
mendation for Copying a Volume, the vol copy start command generates one
or more error messages. Table 15-4 explains the meanings of the possible error
messages.
0DQDJHPHQWRID9ROXPH&RS\2SHUDWLRQ:KHQLW,VLQ3URJUHVV

&KHFNLQJWKH6WDWXVRID9ROXPH&RS\2SHUDWLRQ

You can use the following command syntax to check the status of one or more vol-
ume copy operations:
vol copy status [
operation_number
]

7DEOHYROFRS\VWDUW&RPPDQG(UURU0HVVDJHV

(UURUPHVVDJH 0HDQLQJ
Permission denied.
VOLCOPY: Could not connect to
filer 127.0.0.1.
The source filer does not have per-
mission to copy to the destination
filer.
Action: Make sure that the filers
have a trusting relationship with each
other. If both the source volume and
destination volume are on the same
filer, remember to include localhost in
the /etc/hosts.equiv file.
VOLCOPY: volcopy restore:
volume is online, aborting
The destination volume is on-line.
Action: Take the destination volume
off-line and reboot the filer that con-
tains the destination volume.
VOLCOPY: volcopy restore:
volume is too small, aborting
The destination volume is smaller
than the source volume.
Action: Add more disk space to the
destination volume or choose another
destination volume of sufficient
capacity.