7-38 Dell PowerVault 720N, 740N, and 760N System Administrator and Command Reference Guide
6. To disconnect one or more users, do one of the following:
To disconnect a single user or selected users, select them, then click
Disconnect.
To disconnect all users, click Disconnect All.
Result: The selected users are disconnected.
NOTE: If at least one of the selected users has open resources, an alert box
appears for you to confirm or cancel your command.
8VLQJWKHFLIVWHUPLQDWH&RPPDQG
You can stop CIFS service for a specific client or shut down CIFS service from the filer
by using the cifs terminate command. Always terminate all CIFS sessions before
you reboot or turn Off the filer.
You can specify a single client or all clients, and the time delay, in minutes, before the
CIFS sessions are terminated, as shown in the following command syntax:
FLIVWHUPLQDWH>FOLHQW@>>W@WLPH@
Table 7-8 describes the variables.
7KHFLIVWHUPLQDWH&RPPDQG1RW3HUVLVWHQW
The cifs terminate command disables CIFS sessions only between the time you
enter the command and the next reboot. After each reboot, if your filer is licensed and
configured to run CIFS, the filer automatically starts CIFS service. If you want to pre-
vent CIFS from restarting after a reboot, remove the /etc/cifsconfig.cfg file from the
filer or rename the file.
7LPH'HOD\
You can delay the termination of CIFS service after you enter the cifs terminate
command.

'HIDXOW7LPH'HOD\

The default time delay is five minutes.

7DEOHFLIVWHUPLQDWH&RPPDQG9DULDEOHV

9DULDEOH 'HVFULSWLRQ
client Name of the client for which you are
ending a CIFS session.
time Number of minutes before the termi-
nation happens.