Dell MD3220, MD3200 owner manual Changing Controller Ownership of the Virtual Disk, 119

2In the Defined Mappings pane, perform one of these actions:

•Select a single virtual disk, and select Mappings→ Change→ Mapping.

•Right-click the virtual disk, and select Change Mapping from the pop-up menu.

3In Host group or host, select the appropriate host group or host.

By default, the drop-down list shows the current host group or the host associated with the selected virtual disk.

4In Logical unit number, select the appropriate LUN.

The drop down list shows only the currently available LUNs that are associated with the selected virtual disk.

5Click OK.

Stop any host applications associated with this virtual disk, and unmount the virtual disk, if applicable, from your operating system.

6In the Change Mapping dialog, click Yes to confirm the changes.

The mapping is checked for validity and is saved. The Defined Mappings pane is updated to reflect the new mapping. The Topology pane is also updated to reflect any movement of host groups or hosts.

NOTE: If a password is set on the storage array, the Enter Password dialog appears. Type the current password for the storage array, and click OK.

7If configuring a Linux host, run the rescan_dm_devs utility on the host, and remount the virtual disk if required. This utility is installed on the host as part of the MDSM install process.

8Restart the host applications.

Changing Controller Ownership of the Virtual Disk

If the host has a single data-path to the MD storage array, the virtual disk must be owned by the controller to which the host is connected. You must configure this storage array before you start I/O operations and after the virtual disk is created.

You can change the RAID controller module ownership of a standard virtual disk or a snapshot repository virtual disk. You cannot directly change the RAID controller module ownership of a snapshot virtual disk because the

Configuration: Disk Groups and Virtual Disks

119