Dell MD3220, MD3200 owner manual Setting a Password, Type the New password

Setting a Password

You can configure each storage array with a password to protect it from unauthorized access. MDSM prompts for the password when an attempt is made to change the storage array configuration, such as, when a virtual disk is created or deleted. View operations do not change the storage array configuration and do not require a password. You can create a new password or change an existing password.

NOTE: It is recommended that you use a long password with at least 15 alphanumeric characters to increase security.

To set a new password or change an existing password:

1Select the relevant storage array and navigate to the AMW for that storage array. See "Array Management Window" on page 61.

The AMW for the selected storage array is displayed.

2In the AMW, perform one of these actions:

•Select the storage array in the Logical pane, and then select Storage Array→ Set Password.

•Select the Setup tab, and then click Set a Storage Array Password.

•In the AMW, select the Logical tab, right-click and select Set

Password.

The Set Password dialog appears.

3If you are resetting the password, type the Current password.

NOTE: If you are setting the password for the first time, leave the Current password blank.

4Type the New password.

5Re-type the new password in Confirm new password.

NOTE: The password in Confirm new password and New password must be exactly the same.

6Click OK.

NOTE: You are not prompted for a password when you attempt to change the storage array configuration in the current management session.

Configuration: About Your Storage Array

69