Dell Model PP06XA service manual Replacing the Display Panel, Removing the Display Panel Cable

1	camera cable connector	2	display panel
3	screws (12)	4	light lobes connector

6Disconnect the light lobes connector using the pull-tab.

7Remove the display panel.

Replacing the Display Panel

1Replace the light lobes connector.

2Replace the eight screws that attach the display panel brackets to each side of the display panel.

3Align the display panel with the display back and replace the four screws.

4Connect the LCD camera cable to the display panel.

5Route the cables back through their routing channels.

6Replace the display bezel (see "Replacing the Display Bezel" on page 41).

Removing the Display Panel Cable

1Remove the display assembly (see "Removing the Display Assembly" on page 37).

2Remove the display bezel (see "Removing the Display Bezel" on page 40).

3Remove the display panel (see "Removing the Display Panel" on page 41).

4Turn over the display panel, placing it on a clean surface.

NOTICE: To avoid damage to the computer when replacing the bottom flex cable, gently support the bottom of the inverter board with one finger as you reseat the bottom flex-cable connector. Do not bend the inverter board.

5Gently pull the pull-tab from the bottom flex-cable connector to release the cable from the inverter board.

6Squeeze the flex-cable release levers at either side of the top flex-cable connector, releasing the connector.

42

Display Assembly