Figure 18. Removing and Installing a Processor/DIMM Blank
1. processor socket
2. processor/DIMM blank
3. tabs (2)
4. heat sink retention sockets (2)

Installing A Processor/DIMM Blank

1. Remove the blade from the sleeve.
2. If installed, remove the processor and heat sink. For more information, see Removing A Processor.
3. Remove the blade system board. For more information, see Removing The Blade System Board.
4. Position the processor/DIMM blank on the blade system board with the holes on the tabs of the processor/DIMM
blank engaged with the heat sink retention screws on the blade system board.
5. Install the blade system board. For more information, see Installing The Blade System Board.
6. Install the blade in the sleeve.
System Memory
Your system supports registered DIMMs (RDIMMs). It supports DDR3 and DDR3L voltage specifications.
NOTE: MT/s indicates DIMM speed in MegaTransfers per second.
43