Dell 6P317, RPS-60 setup guide Mounting Instructions, Technical Information

w w w . d e l l . c o m s u p p o r t . d e l l . c o m

Mounting Instructions

NOTICE: Before you install the PowerConnect™ RPS-60, consult the User's Guide for your PowerConnect switch to confirm that your switch supports the PowerConnect RPS-60 redundant power system.

The PowerConnect RPS-60 is an external redundant power system that provides a second redundant power supply for your PowerConnect switch, eliminating the power supply as a single point of failure. To use the RPS-60:

1Attach the adapter tray to the back of the switch by tightening the two mounting screws.

2Insert the power adapter into the tray.

3Plug the power adapter’s DC cable into the connector labeled "RPS" on the back of the switch.

4Connect the AC power cable to the power adapter, and then plug it into an electrical outlet.

The switch is now using both power supplies simultaneously. You can monitor the status of the two power supplies with the front-panel LEDs on your PowerConnect switch.

Technical Information

Input Characteristics

Input voltage range	90	VAC to 264 VAC, single phase
Input frequency range	47	Hz to 63 Hz
Max. input AC current	1.5 A at 130 VAC; 1 A at 230 VAC
Inrush current (cold start)	50	A at 115 VAC; 100 A at 230 VAC
Efficiency	80% minimum at 115-VAC input full load
Output Characteristics
Static output characteristics (Vo)
Output voltage	12 V ± 5%
Load range minimum	0 A
Load range maximum	5 A
Peak (1sec)	6 A

10

Dell PowerConnect RPS-60 Setup Guide