ENGLISH
4 |
| q Select the “Start”. |
|
| |
|
| *Auto Setup |
| (Remote control unit) | Start |
|
|
w Press the CURSOR left button.
About the error message
These error screens will be displayed when performing the measurements of Auto Setup / Room EQ and the automatic measurements can not be completed because of the speaker arrangement, measurement environment, or other factors. Please check the following matters, reset the pertinent items, and measure again. When there is too much noise in the room, the speakers may not be detected properly. Should this happen, perform the measurements when the noise level is low, or switch off the power of the equipment that is producing the noise for the duration of the measurements.
(Remote control unit)
q This screen will be displayed when the speakers |
required for producing suitable reproduction have |
not been detected. |
• The front L and front R speakers were not |
e This screen will be displayed when accurate |
measurements cannot be made due to the input |
level to the microphone being too high. |
Set up the speakers so that their position is |
5 | Start the measurements. |
|
|
|
|
|
|
| ||||||||||||
Measurement of each channel is performed as follows. | ||||||||||||||||||||
| Display |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||||
| 1 |
|
|
| 2 |
|
|
| 3 |
|
| |||||||||
|
| FL |
|
| FR |
| C |
|
| SW |
|
| SL |
| SR |
|
| SBL |
| SBR |
|
|
|
|
|
|
|
|
|
|
|
|
|
1 Only the front speakers (A) is measured. Even if the front speakers (B) is set, the setting automatically switches to the front speakers (A) once measurements are completed.
2 Subwoofer speaker is measured twice.
3 When “ZONE2” is selected, this is not displayed. After each channel is measured, “Calculating” appears.
The display switches to Auto Setup check screen automatically.
NOTES:
•Measurement is canceled when MASTER VOLUME is operated while the Auto Setup is performed.
•Set the volume to halfway and set the crossover frequency to the maximum or low pass filter off if your subwoofer can adjust the output volume and the crossover frequency.
properly detected. |
• Only one channel of the surround speakers was |
detected. |
• Sound was output from the R channel when |
only one surround back speaker was connected. |
• The surround back was detected, but the |
surround speaker was not detected.
Check that the pertinent speakers are properly connected.
(see page 9)
wThis screen will be displayed when the speaker polarity is connected in reverse.
Check the polarity of the pertinent speakers. For some speakers, the screen below may be displayed even though the speakers are properly connected. If so, select “Skip0”.
farther away from the listening position. |
Lower the volume of the subwoofer. |
rThis screen will be displayed when the measurement microphone is not connected, or when all of the speakers have not been detected.
Connect the measurement microphone to the microphone connector.
Check the speaker connections.
About automatic retry
Remeasurement starts automatically to receive proper result of measurement. Remeasurement is performed to 2 times, and “Retry1” or “Retry2” is displayed on screen during remeasurement.
14