[2]Remote control unit operations during
This operation is possible when ZONE2 mode is selected.
ENGLISH
11SURROUND
Before playing with the surround function
1 | Select “ZONE2” using the |
ZONE2 button. | |
| (Remote control unit) |
2 | Press the ZONE2 “ON” |
button. |
2
1
The main zone output can be turned on and off with the “MAIN ON/OFF” button.
•Before playing with the surround function, be sure to use the test tones to adjust the playback level from the different speakers. This adjustment can be performed with the system setup (see page 20) or from the remote control unit, as described below.
•Adjusting with the remote control unit using the test tones is only possible in the “Auto” mode and only effective in the STANDARD (DOLBY/DTS SURROUND) modes. The adjusted levels for the different modes are automatically stored in the memory.
|
| To turn off the ZONE2 |
| (Remote control unit) | mode. |
|
| Press the ZONE2 “OFF” |
|
| button. |
3 | Press the input source button | |
• The ZONE2 source switches directly. | ||
4 | The output level of the ZONE2 OUT terminals | |
can be controlled using the VOLUME + and – | ||
| buttons on the remote control unit. | |
| The output level of ZONE2 OUT can be | |
| controlled only | if ZONE2 vol. level is set |
| “Variable” at Zone2 Control in System Setup | |
| Menu. (see page 26) | |
| DEFAULT SETTING | |
| (ZONE2 VOLUME LEVEL) : | |
| - - - dB (MINIMUM) | |
|
| (Remote control unit) |
3
5
4
1 | Press the TEST TONE button. | ||
| |||
(Remote control unit) |
|
|
|
2 | Test tones are output from | ||
the | different | speakers. Use | |
| the | channel | volume adjust |
| buttons to adjust so that the | ||
| volume of the test tones is | ||
(Remote control unit) | the same for all the speakers. | ||
3 | After | completing | the |
adjustment, press the TEST | |||
TONE button again.
(Remote control unit)
2
2
1, 3
5 | When the ZONE2 SOURCE |
function is set to TUNER, the | |
| preset channel can be |
| selected using the CHANNEL |
•After adjusting using the test tones, adjust the channel levels either according to the playback sources or to suit your tastes, as described below.
+ and – buttons | on the |
(Remote control unit) remote control unit. |
|
1 | Select the speaker level you |
want to adjust. |
(Remote control unit)
The channel switches as shown below each time the button is pressed.
| FL |
|
| C |
|
|
|
| FR |
|
| SR |
|
| SBR |
|
| SBL |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
| FADER |
|
|
|
| SW |
|
|
| SL |
|
|
|
| ||
2 | Adjust the level of the |
selected speaker. |
(Remote control unit)
When the surround back speaker setting is set to “1spkr” for “Speaker Configuration”, this is set to “SB”.
2
2
1
NOTES:
•The adjustment range for the different channels is +12 dB to
•The sound from the subwoofer can be cut by lowering the SW (subwoofer) setting one step from
39