ENGLISH

System call

The accessorious remote control unit is equipped with “system call” function allowing a series of remote control signals to be transmitted by pressing a single button.

This function can be used for example to turn on the amplifier’s power, select the input source, turn on the monitor TV’s power, turn on the source component’s power and set the source to the play mode, all at the touch of a button.

(1)

System call buttons

 

Up to 10 signals each can be stored at the

 

“CALL1” and “CALL2” buttons.

(2)

Storing system call signals

 

 

1

Press the power ON/SOURCE button and the

OFF button at the same time.

•The LEARNED/TX indicator flashes.

11

Punch Through

(1)Punch through button

Buttons used in the CD, CDR/MD, TAPE, DVD/VDP, and VCR modes can be assigned to the buttons shown on the diagram at the right which are not normally used in the TV and DBS/CABLE modes.

For example, when the CD mode is set to the punch through mode in the TV mode, the CD mode’s PLAY, STOP, MANUAL SEARCH, AUTO SEARCH, PAUSE and DISC SKIP buttons’ signals are sent in the TV mode.

(2)Making the punch through setting

1

Press the power ON/SOURCE button and the

OFF button at the same time.

• The LEARNED/TX indicator flashes.

11

3

2

Press the CALL 1 button.

• The mode selector buttons and LEARNED/TX

indicator flash.

3

Press the mode buttons of the equipment that

is to be registered to System Call.

4

Press the buttons whose remote control signals

 

you want to store one by one.

 

5

Repeat steps 3 and 4 to register the desired

 

buttons.

 

6

 

2, 6

Press the CALL1 or CALL2 button and register

6

System Call.

 

2 Press the 1(play) button.

• TV and DBS/CABLE mode buttons and LEARNED/TX indicator flash.

3

Press the mode button of the equipment for

which Punch Through is to be set.

• The CD, CDR/MD, TAPE, DVD/VDP, and VCR mode buttons and LEARNED/TX indicator will flash.

4

Press the mode button of the equipment that is

to be punched through.

• The mode button that was set will light.

3

2

4

(3) Using the system call function

1

Press

the button at which the

system call

signals have been stored.

 

 

• The

stored signals are

transmitted

 

successively.

 

NOTES:

•The remote control signals for the buttons pressed while storing the system call signals are transmitted when the buttons are pressed, so cover the remote sensor or take other measures so that the components do not operate while the signals are being stored.

•The mode button and LEARNED/TX indicator flashing rapidly if you have already stored the maximum number of signals.

32