Check of the measurement results

1

 

Select the items.

 

The measurement results of each item can be checked

 

 

here.

 

 

*Auto Setup

 

(Remote control unit)

Sp Config . Check

 

 

2

 

Press the ENTER button and display the verification

 

screen.

(Remote control unit)

NOTE:

•When measurements have been made using the measurement microphone, speakers with a built-in filter such as subwoofers might be set with a value that differs from the physical distance because of the internal electrical delay.

[Speaker Config. Check]

[Delay Time Check]

[Channel Level Check]

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

3

If the check ends, press the ENTER button again.

 

 

(Remote control unit)

 

4

Select from the following three items based on the

measurement results.

 

• Store

: Set with the checked measurement value.

 

• Retry

: Perform the measurement again.

 

• Cancel : Cancel the checked measurement value.

 

(Remote control unit)

 

 

 

*Auto Setup

 

 

Store

5

When the “Store” is selected, all parameters are stored

up.

 

When the “Retry” is selected, it measures again.

(Remote control unit)

ENGLISH

1-2 Setting the Manual EQ Setup

Adjust the tone of the various speakers except subwoofer while listening to the sound (music).

1

Select “Manual EQ Setup” at the Auto Setup / Room

EQ Menu.

 

 

 

 

 

*AutoSet/RoomEQ

(Remote control unit)

Manual

EQ

Setup

 

 

 

 

 

2

Display the Manual EQ Setup screen.

 

(Remote control unit)

 

 

 

 

 

 

*ManualEQ

Setup

 

 

Channel

:

FL

 

3

Select the speaker to be set.

 

 

The display changes as follows.

 

 

FL

FR

 

C

SL

(Remote control unit)

SBR

SBL

 

SR

 

 

SB

1spkr

 

Flashing

 

When the surround back speaker setting is set to

 

“1spkr” at “Speaker Configuration”, this is set to

 

“SB”.

 

 

 

 

 

*ManualEQ

Setup

4

Channel

:

FL

 

Select the frequency.

 

 

 

 

 

 

 

 

 

 

*ManualEQ

Setup

(Remote control unit)

63Hz

:

0 . 0dB

 

 

 

 

 

 

5

Use the cursor left and right buttons to adjust the Gain

level.

 

 

 

 

 

• Each frequency can be adjusted the range from –6 dB

 

to +6 dB in 0.5 dB step.

 

 

 

(Remote control unit)

 

 

 

 

 

6

Enter the setting.

 

 

 

 

The Auto Setup / Room EQ Menu reappears.

(Remote control unit)

15