The surround mode used at last for the three types of input signals shown below is stored in the memory, and the signal is automatically played with that surround mode the next time it is input.
Note that the surround mode setting is also stored separately for the different input sources.
qAnalog and PCM
w
e
During playback in the PURE DIRECT mode, the surround mode does not change even if the input signal is changed.
1 | Select “Auto Surround Mode” at the Advanced | |
Playback Menu. |
| |
| *Advanced | Play |
(Remote control unit) | Auto Surround | |
|
| |
2 | Press the ENTER button. |
|
Display the Auto Surround Mode screen. | ||
(Remote control unit) |
|
|
3 | Select “ON” if you want to use the auto surround mode, | |
“OFF” if you do not want to use it. | ||
(Remote control unit) | *Auto Surround | |
| ON/OFF: | ON |
4 | Enter the setting. |
|
The Advanced Playback Menu reappears. | ||
(Remote control unit)
Contents stored in the auto surround mode can be checked with the
(Remote control unit)
ENGLISH
5 | Setting the Option Setup |
| |
1 |
| Select “Option Setup” at the System Setup Menu. | |
|
| ||
| (Remote control unit) | *System | Setup |
2 | Option | Setup | |
| Display the Option Setup Menu Screen. | ||
|
| ||
(Remote control unit)
Make this setting to switch the power amplifier for the surround back channel to ZONE2.
If ZONE2 is selected, the signal that selected at ZONE2 is output at “SURR. BACK ZONE2 PREOUT” terminals.
1 |
| Select “Power Amp Assign” at the Option Setup Menu. |
|
| |
|
| *Option Setup |
| (Remote control unit) | P . Amp Assign |
|
| |
2 |
| Press the ENTER button. |
| Display the Power Amp Assign screen. | |
| (Remote control unit) |
|
3 |
| Select “Surround Back” to use as the surround back channel, “Zone2” to use as |
| Zone2 out. |
(Remote control unit)
*P . Amp Assign
S . Back
When “Surround Back” is | When “Zone2” is selected |
selected |
|
4 | Enter the setting. |
The Option Setup Menu reappear. |
(Remote control unit)
25