Operating external devices with the remote control

By registering preset codes for external devices to the provided remote control, you can operate your TV and playback devices (such as Blu-ray Disc player and DVD player) with the remote control.

version Basic

Registering preset codes

When preset codes are registered in the included remote control unit, it can then be used to operate any devices you have, such as DVD players or TVs made by different manufacturers.

nnButtons used for operating the devices

qDEVICE X

For switching power of each device on or off.

wuio p, ENTER, BACK

For menu operation of each device.

eMENU, INFO, OPTION, SETUP

For displaying the menu of each device.

r8, 9, 1, 6, 7, 3, 2 t Number button (0 – 9, +10)

y CH/PAGE df u TV X, TV INPUT

For operating a TV

This button is enabled in any mode.

For details on operation with the remote control unit, see pages 41, 44, 53, 56, 60, 63, 66, 68, 149, 150

NOTE

The preset code cannot be registered to TUNER, PHONO, iPod/USB, NETWORK and INTERNET RADIO.

Registering preset codes

1 Press and hold down the input source select buttons for the appliance to control, and press SETUP until the operation mode indicator blinks.

NOTE

Note that the group numbers that can be registered are predefined for each input source select button.

2 Press the 5-digit code for the appliance using 0 – 9 (code table at the end of this manual).

When the procedure is successful, the operation mode indicator blinks twice.

NOTE

If the operation mode indicator did not blink twice, then repeat steps 1 and 2 and try entering the same code again.

Some manufacturers use more than one type of remote control code. Preset codes to change the number and verify correct operation.

NOTE

Depending on the model and year of manufacture of your device, some buttons may not operate.

version Advanced

Informations

DVD

145