Set up speakers | around items indicate the settings. |
This section describes detailed settings for Audyssey® Setup.
First install and connect the speakers to this unit.
Before Audyssey® Setup measurement, the settings shown below can be made.
•Changing the amplifier assignment (Amp Assign)
The signal output from the SURROUND BACK speaker terminal of this unit can be switched to match your speaker environment (vpage 92 “Set up “Amp Assign””).
•Setting the channels to be used (Channel Select)
If channels that are not to be used are set in advance, measurement for the set channels is skipped, and measuring time can be reduced. You can also change the number of surround back speakers (vpage 93 “Set up “Channel Select””).
version Basic
1 | Set up the | 2 | Connect the setup microphone. |
| |||
remote control unit |
| ||
|
|
|
nn Set up the zone mode
Press MAIN to switch the zone mode to the MAIN
ZONE.
MAIN lights.
When the setup microphone is connected, the following screen is displayed.
3 | Set up “Amp Assign” |
Use ui to select “Amp Assign”, and then press
ENTER.
Audyssey Setup
Your AV receiver can automatically measure the acoustics of your room then optimize your speakers using the included microphone.
Set the following items if necessary.
Amp Assign
Channel Select
version Advanced
Informations
Press MAIN
NOTE
When using a remote control with preset codes registered (vpage 148), press AVR to set the remote control to the AVR- operation mode before operation.
Audyssey Setup
Your AV receiver can automatically measure the acoustics of your room then optimize your speakers using the included microphone.
Set the following items if necessary.
Amp Assign
Channel Select
Start
Start
Amp Assign |
|
Assign Mode | ZONE2 |
ZONE2: 
ZONE3: 
Selects how to use the internal amplifiers
4 Select “Assign Mode”, and then press ENTER.
v See overleaf
DVD | 92 |