Troubleshooting Information Zone-Multi Control Remote Playback Setup Connections Started Getting

hTrigger Out 1

Select the conditions to turn on the trigger out 1 with respect to the zone, input source, surround mode.

For details about the trigger out function, see page 21.

jTrigger Out 2

This sets the conditions to turn on the trigger out 2, in the same way as “Trigger Out 1” above.

[Selectable items] ON – – –

Setting with Respect to the Zone

•When the power of the zone turned on/off, the trigger out turns on.

•Associated with the power supply of zones set to “ON”.

Setting with Respect to the Input Source

•When the input source set to on is selected, the trigger out turns on.

•Associated with respect to the input source for zones set to “ON” at “Setting with Respect to the Zone”.

Setting with Respect to the Surround Mode

•When the surround mode set to on is selected, the trigger out turns on.

•Associated with respect to surround modes that are set to “ON”.

•This can be set if the “MAIN ZONE” setting at “Setting with Respect to the Zone” is set to “ON”.

•Associated when an input source for which “Setting with Respect to the Input Source” is set to “ON” is selected.

35

kRemote ID

Set remote control ID.

Match the ID setting of the remote control unit and the receiver.

[Selectable items] 1 2 3 4

•When changing the remote ID, also change the AMP, iPod, TU and NET/DTU modes of the main remote control unit at the same time (vpage 62).

•When changing the remote ID, also change the sub remote control unit at the same time (vpage 67).

l2Way Remote

Make setting for 2-way remote control unit.

[Selectable items] Used Not Used

When using a 2-way remote control unit (RC-7000CI and RC-7001RCI, sold separately), set this to “Used”.

A0Dimmer

Adjust display brightness of the receiver.

[Selectable items] Bright Dim Dark OFF

Operating from the main unit

Press the DIMMER button.

Bright Dim

OFF Dark

A1Setup Lock

Protect settings from inadvertent change.

[Selectable items] ON OFF

•When “Setup Lock” is set to “ON”, the settings listed below can no longer be changed. Also, “SETUP LOCKED!” is displayed if you attempt to operate related buttons.

⋅GUI menu operations

⋅RESTORER

⋅Night Mode

⋅Parameter

⋅Room EQ

⋅Channel Level

⋅Audio Delay

•To cancel the setting, press the MENU button to re-display the “Setup Lock” screen, then change the setting to “OFF”.

A2Maintenance Mode

This sets the function for maintenance by a DENON serviceperson or installer. (For professional use only.)

This function allows a DENON serviceperson or installer to check the AVR-3808CI’s status and make settings via the Internet.

NOTE

Only use this function if so instructed by a DENON serviceperson or installer.