Troubleshooting Information
<SOURCE SELECT> uiop
| <ON/STANDBY> | ENTER <STATUS> | |
[ | TU] | [ iPod] | |
(DEVICE2 | [8], | ||
mode) | |||
|
| [9], | |
| [f] | [6], | |
| [7], | ||
|
| ||
| ENTER | [1], [2] | |
| [ENTER] | ||
|
| ||
| uiop | [uiop] | |
[SEARCH] | [SEARCH] | ||
|
| [CHANNEL | |
| [SAT TU] | ||
|
| ||
(AMP mode) | [iPod] | ||
[NUMBER] | |||
(AMP mode) | |||
(Main remote control unit)
[2] 
[1/3]
[8] 
[9]
[REPEAT] 
[RANDOM]
(Sub remote control unit)
About the button names in these explanations
<> : Buttons on the main unit
[ ] : Buttons on the remote control unit
Button name only:
Buttons on the main unit and remote control unit
Checking the XM Signal Strength and Radio ID
1Either turn <SOURCE SELECT> or press [SAT TU]
(AMP mode) to select “XM”.
2Press <STATUS> until “SIGNAL” appears on the display.
The display will switch as shown below, depending on the reception conditions.
Display | GUI | Status | ||
GOOD |
|
|
| Signal strength is good |
|
|
| ||
|
|
|
|
|
MARGINAL |
|
|
| Signal strength is marginal |
|
|
| ||
|
|
|
|
|
WEAK |
|
|
| Signal strength is weak |
|
|
| ||
|
|
|
|
|
NO |
|
|
| No signal |
|
|
| ||
|
|
|
|
|
3Adjust the position of the antenna until “SIGNAL: GOOD” is shown on the display.
4Press <STATUS> until the station you want to check (example: “XM001”) is displayed.
5Press [f] and select channel 0 (XM000). The radio ID is shown on the display.
Radio ID
The strength of both the XM satellite and terrestrial signals can be checked at GUI menu “Source Select” – “XM” – “Antenna Aiming” (vpage 40).
Searching Categories
1Press op.
Channel category
2Use opto select the category, then use uito select the desired station.
Accessing XM Radio Stations Directly
1Press [SEARCH].
2Press [NUMBER] then input the station’s channel.
Example: Accessing station “XM123”: [1] → [2] → [3]
b If no button is pressed within several seconds, the station automatically switches to the one whose number has been input.
3Press ENTER to set that station. Reception switches to the selected station.
•“LOADING” is displayed while stations or data are being received.
•“UPDATING” is displayed while the encoding code is being updated.
•“XM - -
49