Denso BHT-7500 Terminal Setup Using Twin Client Menus, Edit Mobile Unit IP, Edit Server/Host IPs

Terminal Setup

Printer Type

This scrolling list selects the attached printer type. The default value is none, indicating that no printer is attached.

Terminal Setup Using Twin Client Menus

The Twin Client terminal software provides an internal menu system for configuring certain parameters on the terminal and for switching between Server and Telnet modes of operation.

To access this menu system for the BHT 7500 terminal, press uppercase C at the startup screen as shown in the following figure.

Twin Client

© 1991-2006, Connect, Inc.

Keypress to Continue

The following screen appears.

Edit Menu Options

Edit Mobile Unit IP

Edit Server/Host IPs

Edit License Key

Run Site Survey

Switch Client Modes

Run Client Emulator

Exit to OS

Use the Up-Arrowand Down-Arrowkeys to navigate the menu, and press Enter to select the highlighted option. Each menu option is described below.

Edit Mobile Unit IP

The IP list contains the terminal IP address, the Subnet Mask and the Router IP address. Enter the appropriate address and select F3 to save and/or F7 to Quit.

IP 206.232.71.38

SN 255.255.255.0

RT 206.232.71.1

<F3> Save <F7> Quit

Edit Server/Host IPs

If the host IP address(es) were not pre-configured as described in the Setting the Servers section of Configuring the Manager, or if you wish to change those settings using the terminal menus, select this option and enter up to four Host IP addresses as required.

2-24 Supported Equipment Manual • March, 2006