Denso BHT-103, BHT-7500 manual Introduction, Release Notes, Descriptions

Chapter 1 • Introduction

Release Notes

1.For the 7500W terminal only (not 7500S) in all emulations, setting the backlight timer in the Timers tab to 5 seconds or more enables the backlight when the trigger (or any key) is pressed.

2.For the 7500W terminal only (not 7500S) in all emulations, choosing Spec 1 in the Mode scrolling list box under the Alarm tab enables vibrate only, and choosing Spec 2 enables vibrate and beep.

3.Denso 103: firmware version E001 is required. Denso 7500W: firmware version

SB06 or newer is required. Denso 7500S: latest firmware version 1.12 is required.

4.Denso 103: in all emulations, scanning of 2D barcodes of up to 500 characters is supported.

Descriptions

The Denso BHT-7500 measures 203 mm H x 75 mm W x 50 mm T, and weighs approximately 10.6 oz (300 g). This terminal meets the environmental requirements of an operating temperature of -5°C to 50°C and a drip-proof requirement of JIS drip-proof II. The BHT-7500 terminal is powered by a Lithium-ion battery cartridge (not included). Auxiliary functions include: clock, beeper, resume functions, low battery indication, and remote wake-up function.

Additional features of this terminal are as follows:

•Controller Unit

o 32-bit RISC memory

o 8.5 MB memory (User's area: 6.5 MB)

Note: The Controller Unit is required for operation of the terminal.

•Display Unit o backlight

o FSTN liquid crystal dot matrix display device o 160x159 pixel display

Supported Equipment Manual • March, 2006 1-1