Denso BHT-103, BHT-7500 manual Quick Start, Configuring the Manager

Quick Start

Quick Start

Quick Start describes how to prepare the Twin Client Manager and the Denso terminal for a Telnet session with the host. Following an initial serial download, the terminal software and configuration is managed automatically, over the wireless network.

Note: Denso terminals are normally delivered with Denso files pre-installed.

Configuring the Manager

The first step is to configure the Twin Client Manager to meet site-specific requirements, and then prepare it for the automatic management of the terminal software and IP addresses. This simple procedure will require only a few minutes to complete.

Setting the Emulation

Click on Start, Programs, PowerNet, and Twin Client Manager. Select the Settings menu.

Click on Emulation, select the desired emulation, and click on OK.

Setting the Servers

The Servers are the Telnet host systems the terminals will access.

Supported Equipment Manual • March, 2006 2-5