TX 4000 PCI SS7 Network Interface Board Installation Manual | Installing the TX 4000 board |
DIP switch S1
DIP switch S1 controls the operation of the board. By default, only switch 2 (AUTOSTART) is set to the ON position; all other S1 switches are set to the OFF position. Switch 5 is reserved for future use. Do not modify the default settings for this switch.
Set switch 8 (SW MIN BOOT) to ON to boot the board to the original software image instead of using the current production software image. This allows for recovery from any condition that resulted in the corruption of the production software image. After setting this switch to ON, use txreset to boot the backup software image, and then use txflash to burn a clean copy of the production image. Once the production image is completely transferred to the board's flash memory, turn this switch to OFF, and issue txreset to boot the board using the newly loaded production software image.
Dialogic Corporation | 19 |
