Board status LEDs, Boot code Leds | Dialogic TX4000 PCI SS7 guide

TX 4000 PCI SS7 Network Interface Board Installation Manual

Verifying the installation

Board status LEDs

In addition to external connection status LEDs and Ethernet LEDs, the following banks of LEDs (D6-D21) located on the back of the TX 4000 board indicate the current status of the board:

•Boot code LEDs

•Status LEDs

The following illustration shows the TX 4000 board status LEDs:

Status LEDs

Boot code LEDs

D9

D13

D19

D21

	D8	D7	D6
	D12	D11	D10
		D15	D14
	D18
		D17	D16
	D20

Boot code LEDS

The boot code LEDs are active when the TX 4000 board is powered up. These LEDs progress through a series of red codes. If the power up is successful, these LEDs turn green.

If no LEDs illuminate, the voltage levels may be too low, or the power supply may not be providing enough 3.3 V or 5 V of current to power up the TX 4000 board.

Dialogic Corporation

39

Image 39

Dialogic TX4000 PCI SS7 installation manual Board status LEDs, Boot code Leds

Contents

July Copyright and legal notices Revision Release date Revision historyPage Table Of Contents Hardware specifications Current terminology IntroductionPage TX 4000 board features Overview of the TXBoard TX 4000 board provides PCI bus connectivity Software components Utility Description Utilities and demonstration programs Program Demonstrates how to Page System requirements Installing the TX 4000 board Step Description For details, refer to Installation summary Configuring H.100 bus termination Configuring the hardware Configuring SS7 Monitor mode DIP switch S1 Step Action Installing the board Configuring the TX 4000 board Using the configuration utilityDirectory Txcpcfg Assigning a CP number Adding a board Changing a CP number Txcpcfg bus slot updatedCPnumber Moving a board Removing a board # Command Bus Slot CP Number Txcpcfg Saving configuration changesPage Dialogic MD1 RJ-45 interface Connectors and cablesEstablishing network Connections Ethernet interfaces Dual T1/E1 120 ohm adapter cable Connecting to the network T1 network considerations E1 network considerations Testing in loopback mode TDM configuration Connecting TX boards for redundancy IP network configuration Single-node redundant signaling server Dual-node redundant signaling server Verifying the installation Off Trunk has not been configuredExternal connection status LEDs Following table describes the functionality of each LED Ethernet LEDs Board status LEDs Boot code Leds Status LEDs Color Status when illuminated Number Verifying the board installation Page Physical Hardware specificationsGeneral hardware specifications Feature Specification Software environment Power requirementsCompliant interface Environment DSX-1 telephony interface Cept E1 G.703 telephony interfacePage Index Sigtran