Digi DC-190 installation manual RS-232 Specifications 143 Settings, Not used set to

4.4RS-232 Specifications (143 Settings)

To configure RS-232 specifications, press and hold the REZERO key and enter 143 using the numeric keypad. SPC40 appears in WEIGHT display and configuration of four bits (for SPEC 40) appears in QUANTITY display. Follow the procedure described in Section 4.1 on page 17 to update the SPEC settings for the 143 access code.

SPECs 40–42 and SPEC 43, bits 0–2, represent the selectable RS-232 output fields.

SPECs 46–59 are not used. All bits for these SPECs must be set to 0.

SPEC	Bit 3	Bit 2	Bit 1	Bit 0
40	Lot Number	Memo (Part Name)	Alternative Part Number	ID Code
	0: Yes	0: Yes	0: Yes	0: Yes
	1: No	1: No	1: No	1: No
41	Net Weight	Gross Weight	Setpoint	Inventory
	0: Yes	0: Yes	0: Yes	0: Yes
	1: No	1: No	1: No	1: No
42	Date and Time	Quantity & Total Quantity	Unit Weight	Tare Weight
	0: Yes	0: Yes	0: Yes	0: Yes
	1: No	1: No	1: No	1: No
43	Autoprint within Setpoints	Non-stable Ouput	Status Output	Scale Number
	0: No	0: No	0: Yes	0: Yes
	1: Yes	1: Yes (allow serial output	1: No	1: No
		with scale in motion)
44	Clear Operator Name	Company Name	Manual Print with Setpoints	Autoprint Overrange
	Each Use (BCP-300)	(BCP-300)	0: Yes	Setpoint
	0: No (operator name held	0: Default only	1: No	0: No
	in register for multiple	1: Input with bar board		1: Yes
	inputs)
	1: Yes
45	Not used	Not used	Print with Zero Quantity	Batch Print Once
			0: No	0: No
			1: Yes
				1: Yes
46–59	Not used: set to 0	Not used: set to 0	Not used: set to 0	Not used: set to 0

Table 4-3. DC-190 143 Settings