GETTING STARTED
EATON PowerXpert®Gateway Series 1000 Card User’s Guide S164201670 Rev 1 7
6. Verify that the PDU is turned on.
7. After a few seconds, press Enter. The Network Settings menu
appears in approximately one minute (see Figure 7).
---------------------------------------------------------
----------------Network Settings ----------------
---------------------------------------------------------
1.Ethernet Port 1 Settings
2.Ethernet Port 2 Settings
3.DNS Server (Primary) : [None]
4.DNS Server (Secondary) : [None]
5.Reset to Factory Defaults and Exit
0.Exit
Selectan option ==> 1
Figure7. Network Settings Menu
If the menu does not appear, press Enter again. If it still does not
appear, check the following conditions:
SVerify the serial line is set to 9600 baud, No parity, 8 data bits,
1 stop bit, and no flow control.
SIf the serial line settings are correct, check the cabling to verify
all connections are secure.
SVerify that your terminal program is on the correct
communication port for the serial connection.
SVerify that the card has power (one or more LEDs on the card
are illuminated). The PDU should be on.
8. Continue to the following section, “IP Address Assignments.”