GETTING STARTED
EATON PowerXpert®Gateway Series 1000 Card User’s Guide S164201670 Rev 1
12
---------------------------------------------------------
------Network Settings: Ethernet Port 1 ------
---------------------------------------------------------
1.Dynamic Addressing (DHCP) Disabled
2.IP Address [None]
3.Subnet Mask [None]
4.Default Gateway [None]
MACAddress 00:60:26:10:89:A8
LinkStatus Enabled
0.Exit to previous menu
Selectan option ==> 1
EnableDHCP? (y/n): n
Figure12. DHCP Control Option
3. Type nand press Enter to disable DHCP control.
4. To set the IP address, type 2and press Enter. Type the IP address
and press Enter.
5. To set the subnet mask, type 3and press Enter. Type the subnet
mask address and press Enter.
6. To set the gateway, type 4and press Enter. Type the gateway
address and press Enter.
7. Type 0to return to the Network Settings menu (see Figure 13).
---------------------------------------------------------
----------------Network Settings ----------------
---------------------------------------------------------
1.Ethernet Port 1 Settings
2.Ethernet Port 2 Settings
3.DNS Server (Primary) : [None]
4.DNS Server (Secondary) : [None]
5.Reset to Factory Defaults and Exit
6.Save & apply all settings
0.Exit without saving
Selectan option ==>
Figure13. Network Settings Menu
8. If you connected Ethernet Port 2 to a separate network, continue to
Step 9 to assign the IP address for Port 2. Otherwise, continue to
Step 11.