Eaton Electrical 1000 Verifying IP Addresses (DHCP Enabled)

GETTING STARTED
EATON PowerXpert®Gateway Series 1000 Card User’s Guide S164201670 Rev 1 9
Verifying IP Addresses (DHCP Enabled)
To verify the IP address assignments:
1. Type 1and press Enter on the Network Settings menu (see Figure 7
on page 7) to display the Network Settings: Ethernet Port 1 menu
(see Figure 8).
---------------------------------------------------------
------Network Settings: Ethernet Port 1 ------
---------------------------------------------------------
1.Dynamic Addressing (DHCP) Enabled
2.IP Address 10.222.51.250
3.Subnet Mask 255.255.255.0
4.Default Gateway 10.222.51.254
MACAddress 00:60:26:10:89:A8
LinkStatus Enabled
0.Exit to previous menu
Selectan option ==>
Figure8. Ethernet Port 1 Menu
2. Verify and record the IP address for Port 1*.
3. Type 0and press Enter to return to the Network Settings menu.
4. If you connected Ethernet Port 2 to a separate network, continue to
Step 5 to verify the assigned IP address. Otherwise, continue to
Step 8.
5. Type 2and press Enter on the Network Settings menu to display the
Network Settings: Ethernet Port 2 menu.
6. Verify and record the IP address for Port 2*.
7. Type 0and press Enter to return to the Network Settings menu.
8. Type 0and press Enter to exit the utility.
* If the IP address field contains [None],pressEnterto return to the Network Settings menu and wait 60 seconds.
Repeat Steps 1 through 8. If the field remains [None], contact your local network administrator to verify that the
DHCP server is responding to requests.