USER SUPPLIED
ATTACHMENT
HARDWARE
Ø 0.39 in Ø 9.9 mm
Figure 5.6.7d Wall Bracket Attachment (For illustration purpose only. Attachment hardware selection is installer’s responsibility.)
4.Provide attachment hardware and secure the supplied Wall Brackets to the mounting structure, complying with all Danger and Caution notes in Section 5.6.1.
NOTE: The Wall Brackets have a weld nut on one side. Be sure to locate this weld nut to the right or left such that the Retainer Bolt can be inserted into the opposite side of the Wall Bracket after the module is mounted.
2X ENCLOSURE MOUNTING BRACKET P/N 0006118
2X
Figure 5.6.8 Enclosure Bracket Installation
5.6.8 ENCLOSURE BRACKET INSTALLATION
Insert each supplied Enclosure Bracket into its slot near each end of the enclosure, verifying the proper orientation of the enclosure. Insert a supplied
Caution: Make sure the brackets are installed so the enclosure orientation will be correct when the enclosure is mounted.
5.6.9 ENCLOSURE INSTALLATION
1. Lift the enclosure onto the structure-mounted Wall Brackets
DANGER: IT IS RECOMMENDED
THAT LIFTING THE ENCLOSURE IN
PLACE BE PERFORMED BYAT LEAST
TWO PEOPLE TO PREVENT IT FROM
FALLING DURING ITS INSTALLATION
2X WALL AND CAUSING POSSIBLE EQUIP-
MOUNTING
BRACKET MENT DAMAGE, INJURY, OR DEATH.
P/N 0006119
CAUTION: For DSAi Clusters with two or more modules mounted one over the other, it is recommended to make all cable connections before lifting the mod- ules onto the wall brackets. See Sections
5.2through 5.5. Once the modules are mounted, access to the connectors may be difficult.
IMPORTANT: When installing modules mounted vertically end to end, install the lower module first.
Figure 5.6.9a Enclosure Installation
26
