Example | EAW DSA250i, DSA230i guide

8.6.5 PROPER DSAI INSTALLATIONS

Here are some examples of DSAi installations that will work reliably, both avoiding loops and keeping EIA- 485 running well. These can be used as a basis for larger and more complex installations.

PC

DSA

PILOT

485	CM1	SLink
	DSA "A"
	PLink

485	CM1	SLink
	DSA "B"
	PLink

485	CM1	SLink
	DSA "C"
	PLink

485	CM1	SLink
	DSA "D"
	PLink

EXAMPLE 1:

This is a simple EIA-485 network connected directly from the PC, which runs DSAPilot, to DSAi "A" and then daisy- chain fashion to "C". Because they are in close physical proximity, Link cables are used to connect the control data and audio to "B" and "D". The termination switch for "C" is on. The termination switch should be off on all the other modules.

Figure 8.6.5a Example 1

Cobranet

Unit

PC

DSA

PILOT

485	CM1	SLink
	DSA "A"
	PLink

485	CM1	SLink
	DSA "B"
	PLink

Ethernet

Switch

485	CM1	SLink
	DSA "C"
	PLink

485	CM1	SLink
	DSA "D"
	PLink

EXAMPLE 2:

This is a standard CobraNet connection. Just like computers connected using Ethernet, each module, whether used singly or in a cluster, requires its own a connection to a network switch. No Link cables are used. The DSAPilot PC communicates to all DSAi modules through the serial bridge in the CobraNet Unit.

Figure 8.6.5b Example 2

40

Image 44

EAW DSA250i, DSA230i owner manual Example

Contents

Page Safety Precautions Read this First Precauciones DE Seguridad LEA Esto Primero EC Declaration of Conformity Contents Page Contents IntroductionUnpacking Shipping Damage Audio Signal Connection ChapterReturning Products to EAW Quick Start Computer Control Connection Daisy Chaining Audio and Computer Signal Between ModulesAC Mains Installation Physical Installation Signal End / Power End System Overview Signal ProcessingDescription Features 4 DSAi Block Diagrams Electronic Applications Engineering Design 4a Angled Radiation Pattern DSAPilot Low Frequency PerformanceComparison to Traditional Products Designing DSAi Systems Installation Analog Audio and EIA-485 Computer Control 2 Audio a & Audio B Recommended Conductor Gauge AWG to 18 AWG / 0.2 mm to 1 mm 3 Basic CobraNet Diagram CobraNet Audio and Computer Control Cabling Fault Detect Supervisory Monitoring 3a Single DSAi Fault on AC Mains Power Connection 2 PowerCon Plug Grounding 4 Fuse 2 Signal End / Power End 3 DSAi Cluster Configurations 4a Wall Mounted 6 Mounting Height Lift the enclosure onto the structure-mounted Wall Brackets Acoustical Installation Initial Set-Up Operation Operational Functions Signal Monitoring Operational Check List Normal Operation Operational ‘DOS’ and ‘DONTS’ Maintenance and Service WarrantyService Items How to Contact EAW Inspections and Maintenance Appendices Troubleshooting DSA250i Only EIA-485 EIA-485 Network Notes CobraNet Support For Ethernet Support For CobraNet DSAi Connections 3a EIA-485 Example 5c Example One path was to the EIA-485 port. So when B responds 6c Example Mechanical Drawings Right Side Back Right Side Full Scale Wall Bracket