Eiki EIP-5000 manual 105

Problem	Check	Page
All buttons on the	• If the “Stack Setting” menu is set to “Slave” and the “Keylock	18
projector and the remote	Level” menu is set to “Level B”, all buttons on the projector and	84
control are unavailable.	the remote control are unavailable. Connect the remote control	85
	to the projector, and then use the remote control to operate the
	projector.
Picture is green on	• Change the input signal type setting.	63
INPUT 1or 2
(COMPONENT).
Picture is pink (no green)
on INPUT 1, 2 or 3
(RGB).
Picture is too bright and	• Image adjustments are incorrectly set.	60
whitish.
The cooling fan	• When temperature inside the projector increases, the cooling	9, 10
becomes noisy.	fan runs faster.	93–95
The lamp does not light	• The lamp indicator is illuminating in red.	94
up even after the	Replace the lamp.
projector turns on.
The lamp suddenly turns
off during projection.
The image sometimes	• Cables incorrectly connected to the projector or the connected	27–36
flickers.	equipment works improperly.
	• If this happens frequently, replace the lamp.	97
The lamps take a long	• The lamps will eventually need to be changed.	97
time to turn on.	The lamps have reached the end of its life. Replace the lamps.
Picture is dark.
The remote control	• Operate the remote control while pointing it at the projector’s	17
cannot be used.	remote control sensor.
	• The remote control may be too far away from the projector.
	• If direct sunlight or a strong fluorescent light is shining on the
	projector’s remote control sensor, place the projector where it
	will not be affected by strong light.
	• The batteries may be depleted or inserted incorrectly. Make	17
	sure the batteries are inserted correctly or insert new ones.

This projector is equipped with a microprocessor. Its performance could be adversely affected by incorrect operation or interference. If this should happen, unplug the projector and plug it in again after more than 5 minutes.

103