Eiki EIP-5000 97

	Maintenance indicator			Problem	Cause	Possible solution

		Normal	Abnormal
		Normal	Abnormal

						• Relocate the projector to an area
					• Blocked air intake	with proper ventilation. (See page
	Temperature			The internal		9.)

			Red on		• Cooling fan break-	• Take the projector to your nearest
	warning	Off	Red on	temperature is	• Cooling fan break-	• Take the projector to your nearest
	warning	Off	(Standby)	temperature is	down	EIKI Authorized Dealer or Service
	indicator			abnormally high.	down	EIKI Authorized Dealer or Service
	indicator			abnormally high.	• Internal circuit failure	Center for repair.
					• Internal circuit failure	Center for repair.
					• Clogged air intake	• Clean the air vents and the intake
					• Clogged intake vent	vent cover. (See page 93.)
					cover

				The lamp does	• The lamp is shut	• Disconnect the power cord from
				The lamp does	• The lamp is shut	the AC outlet, and then connect it
				not illuminate.	down abnormally.	the AC outlet, and then connect it
				not illuminate.	down abnormally.	again.
						again.
			Red on
						• Carefully replace the lamp. (See
	Lamp	Green on		Time to change	• Remaining lamp life	• Carefully replace the lamp. (See
	Lamp	Green blinks				page 97.)
	indicators	Green blinks				page 97.)
	indicators	when the lamp		the lamp.	becomes 5% or less.	• Take the projector to your nearest
1, 2		when the lamp		the lamp.	becomes 5% or less.	• Take the projector to your nearest
1, 2		is warming up.				EIKI Authorized Dealer or Service
		is warming up.				EIKI Authorized Dealer or Service
			Red on	The lamp does	• Burnt-out lamp	Center for repair.
			Red on	The lamp does	• Burnt-out lamp	• Please exercise care when
			(Standby)	not illuminate.	• Lamp circuit failure	• Please exercise care when
			(Standby)	not illuminate.	• Lamp circuit failure	replacing the lamp.
						replacing the lamp.

				The power		• Securely install the cover.
				The power	• The intake vent	• If the power indicator blinks even
	Power	Green on/	Green	indicator blinks in	• The intake vent	when the intake vent cover is
	indicator	Red on	blinks	green when the	cover is open.	securely installed, contact your
				projector is on.		nearest EIKI Authorized Dealer or
						Service Center for advice.

Info

•If the temperature warning indicator blinks and the projector enters the standby mode, the temperature warning indicator starts to illuminate. Check whether any of the ventilation holes are blocked (see page 10) and then try turning the power back on. Wait until the projector has cooled down completely before plugging in the power cord and turning the power back on. (At least 10 minutes.)

•If the power is turned off for a brief moment due to power outage or some other cause while using the projector, and the power supply recovers immediately after that, the lamp indicator will illuminate in red and the lamp may not be lit. In this case, unplug the power cord from the AC outlet, replace the power cord in the AC outlet and then turn the power on again.

•The cooling fan keeps the internal temperature of the projector constant and this function is controlled automatically. The sound of the cooling fan may change during operation because the fan speed may change and this is not a malfunction.