Glossary
Advanced intelligent compression (Page 100)
High quality resizing of lower and higher resolution images to fit the projector’s native resolution.
Width and height ratio of an image. The normal aspect ratio of a computer and video image is 4:3. There are also wide images with an aspect ratio of 16:9 and 21:9.
Optimizes projected computer images by automatically adjusting certain characteristics.
Initial setting image projected when no signal is being output.
Projects a 4:3 image fully within a 16:9 screen by keeping the aspect ratio at 4:3.
Clock adjustment is used to adjust vertical noise when clock level is incorrect.
CLR Temp (Color temperature) (Page 61)
Function that can be used to adjust the color temperature to suit the type of image input to the pro- jector. Decrease the color temperature to create warmer, reddish images for natural flesh tones, or increase to create cooler, bluish images for a brighter picture.
C.M.S. (Color Management System) (Page 64)
Function allows you individually adjust the display characteristics of six colors (R: Red, Y: Yellow, G: Green, C: Cyan, B: Blue, M: Magenta)
Mode that projects images in their native resolution.
Mode that can lock the operation of projector buttons to prevent unauthorized adjustment.
Function to digitally correct a distorted image when the projector is set up at an angle, smoothes out jaggies on keystone images and compresses the image not only horizontally but vertically keeping the 4:3 aspect ratio.
Phase shift is a timing shift between isomorphic signals with the same resolution. When phase level is incorrect, the projected image typically displays horizontal flicker.
The Pict in Pict (picture in picture) function allows you to display two pictures on the same screen. You can display the image input from a video as an inset picture overlapping the main picture input from a computer.
Image quality enhancement function that offers a richer image by brightening the darker portions of the image without altering the brightness of the brighter portions. You can select four different modes: STANDARD, PRESENTATION, CINEMA and CUSTOM.
The progressive display projects a smoother video image. You can select three different modes: 2D Progressive, 3D Progressive and Film Mode.
Allows you to modify or customize the picture display mode to enhance the input image. You can select six different modes: NORMAL, FULL, DOT BY DOT, BORDER, STRETCH and SMART STRETCH.
Function to adjust the position of the projected image for the position of the screen by shifting the lens horizontally and vertically.
Projects the image fully in a 16:9 screen by enlarging only the surrounding areas while keeping the aspect ratio in the middle part of the image at 4:3. Image will be displayed more naturally than using “Stretch” mode.
An international standard of color reproduction regulated by the IEC (International Electrotechnical Commission). As the fixed color area has been decided by the IEC, the color changes according to DLP features, so that the images are displayed in a natural tint based on an original image, when “C.M.S. Adjustment” is set to “sRGB”.
Setting for the stack projection that allows you to increase the brightness of an image by stacking multiple projectors and projecting same image simultaneously. You can control projectors for the stack projection by assigning a projector as the master and the other projectors as the slaves.
Projects the 16:9 image or the squeezed image* fully in a 16:9 screen.
*16:9 image that is squeezed horizontally into 4:3 image.
If the “Keycode” set in the projector is not correctly entered, the projector will not operate even if signals are entered.
105