Pipe Mounting | Emerson 6081-P guide

MODEL 6081-P pH/ORP	SECTION 2.0
	INSTALLATION

2.4.3 Pipe Mounting.

The pipe mounting kit (PN 23820-00/01) accommodates 1-1/2 to 2 in. pipe.

Figure 2-2. Pipe Mounting Installation Model 6081. Use Pipe/Wall Mounting Bracket Kit, PN 23820-00

9

Image 19

Emerson 6081-P instruction manual Pipe Mounting

Contents

Model 6081-P Essential Instructions Shipping considerations for wireless products Power Modules About This Document Quick Start Guide Hart PollAddress Menu Tree for Model 6081 pH Wireless Transmitter Model 6081-P pH/ORP Table of Contents CONT’D Number Title List of FiguresIii This page left blank intentionally Features and Applications Section Description and SpecificationsSpecifications General PH Range 0 to Specifications WirelessFunctional Specifications Measurement update rate 1/sec. to 1/10 min Telecommunication Compliance Hart CommunicationsFCC and IC Asset Management Solutions Considerations Section InstallationUnpacking and Inspection Preamplifier Location PRE-INSTALLATION SetupTemperature Element Reference Electrode Impedance Section Mounting on a Flat Surface Pipe Mounting Installing the Power Module Power Module Installation Section This page left blank intentionally Sensor Wiring Section Sensor WiringGeneral Information This page left blank intentionally This page left blank intentionally Section Intrinsically Safe Installation This page left blank intentionally Section Commissioning Device Network ConfigurationNetwork Communications Verify Operation Screen B Section Display and OperationDisplay Screen a Screen C Information Screen Messages Keypad How the Security Code Works Security This page left blank intentionally Section Operation with Model Off-line and On-line Operation Making Hart related settings from the keypad Section Programming the Transmitter Changing START-UP SettingsGeneral Purpose Choosing and Configuring the Analytical MeasurementDefinitions Choose Soln Temp Corr or Sensor Isoptntl Choose Measurement Purpose Procedure Setting a security code Setting a Security CodeChoose Calib or Config Choose ResetTransmitter Making Hart Related SettingsResetting Factory Calibration and Factory Default Settings Procedure Installing default settings Procedure Changing screen contrast Selecting a Default Screen and Screen ContrastProcedure Choosing a display screen Choose Default Display Procedure Programming the display timeout Choosing a Display Timeout Calibrating Temperature Section Calibration TemperatureIntroduction Procedure Calibration pH and ORP Section Calibration Slope and Offset Choose BufferCal Procedure Auto Buffer Calibration Procedure Manual TWO-POINT Buffer Calibration Choose Standardize Procedure Standardization Procedure Entering a Known Slope Value ORP Calibration Preparation of ORP standard solutions This page left blank intentionally Transmitter Maintenance Section MaintenanceOverview Cleaning Procedures Frequency of Cleaning Rejuvenating Reference Electrodes Checking the Reference Electrode Calibration Frequency ORP Sensor MaintenanceCalibration General Power Module Replacement Environmental Considerations Handling ConsiderationsShipping Considerations General Section Return of Material This page left blank intentionally Warranty Specifications subject to change without notice