About This Document
This document is written by EnGenius Inc. EnGenius Inc. the reserves the right to change this document without notice and all rights are reserved. This document can only be used for the configuration of EnGenius products.
This document is to characterize the EnGenius ENH500 Wireless Access Point & Client Bridge. Please read the document carefully before setting up the ENH500. Any damage which is caused by inappropriate use will not be covered under the warranty.
Formats
This document uses following symbols to indicate and highlight special messages.
Caution: This symbol represents a vital message and it is critical for the device or settings.
Note: This symbol represents an important message for the settings.
Tip: This symbol represents an alternative choice that can save time or resources.
Before you start__________________________________________________
The following equipment is required to setup the ENH500:
1.(1) Computer/Notebook and Internet access.
2.(2) Ethernet cables.
3.(1) EnGenius ENH500.
The equipment listed above is only for configuration of the ENH500, you will
need additional equipment to connect to the Internet and configuration will depend on your current network infrastructure. Please refer to Chapter 2 for more information.
