Follow these steps to use the control panel to select a built-in font:

1.Make sure the printer is on but not printing. If it is, wait until it stops.

2.Hold down the Pause button for three seconds to enter Micro Adjust mode. The Pause light begins to flash and the two Tear Off (Font) lights show the current font selection.

3.Press the Tear Off (Font) button repeatedly to cycle through the fonts, and stop when the lights on the control panel indicate the font you want. Your selection stays in effect until you change it again.

Note:

Settings you make in your application programs usually override settings you make from the printer’s control panel. For best results, use your application to select a font.

Bar code fonts cannot be selected from the control panel.

66Using the Control Panel