Epson 468C Starting the SETUP Program, 2.Run SETUP, 3.Set Password options, 1.Start operating system, 6.SAVE settings and exit, 4.Display system board help

Starting the SETUP Program

To start SETUP, make sure there is no diskette in the diskette drive; then turn on your computer. (If your computer is already on, turn it off, wait 20 seconds, and then turn it on again.) After the self test, you see the following prompt at the bottom of the screen:

Press <Del> if you want to run SETUP

As soon as you see this message, press .

If you do not press within approximately five seconds, the computer starts loading the operating system and you will not be able to run SETUP. If this happens, reset the computer and try again.

When you press [Delete), you’ll see a SETUP menu containing these options:

1.Start operating system2.Run SETUP3.Set Password options4.Display system board help5.Load default SETUP values6.SAVE settings and exit7.Exit without saving settings

Type the number of the menu option you want to select, or use or to move the cursor over the option you want to

select and press As you highlight each menu selection, you’ll see a description of the option at the bottom of the screen.

Running the SETUP Program 2 - 3