Setting the DIP Switches
If you need to change any of the DIP switch settings, follow these steps:
1.Locate the DIP switch block near the center of the system board, shown on page
1 through 5, and the ON position is marked on the block.
2.Use a pointed instrument, such as the tip of a pen, to turn a DIP switch on or off. The new setting takes effect the next time you turn on the computer.
3.Depending on which DIP switch you change, you may also need to run SETUP. For example, if you set DIP switch 4 to ON to enable password security, you then need to enter your password using Set Password options in SETUP. See Chapter 2 for instructions.
Installing and Removing Options 4 - 9