Epson 468C Setting the Peripherals Options

Setting the Peripherals Options

The Peripherals setup option lets you change the settings for the built-in interface ports and disk drive controllers. You may need to change these settings if you install an interface on an option card. The following table lists the possible settings.

I/O control options

Peripherals option	Setting	Description
Serial	C O M l + 2 *	Sets serial port 1 as COM 1 and
		serial port 2 as COM2
	COM1	Sets serial port 1 as COM1,
		disables port 2
	COM2	Sets serial port 1 as COM2,
		disables port 2
	Disabled	Disables both of the serial ports
Parallel	Uni-LPT1*	Sets parallel port as unidirectional
		LPT1
	Uni-LPT2	Sets parallel port as unidirectional
		LPT2
	Bi-LPT1	Sets parallel port as bidirectional
		LPT1
	Bi-LPT2	Sets parallel port as bidirectional
		LPT2
	Disabled	Disables the on-board parallel port
PS/2 mouse	Enabled*	Enables the PS/2 mouse port
	Disabled	Disables the PS/2 mouse port
On-B/D FDC	Enabled*	Enables the on-board diskette
		drive controller
	Disabled	Disables the on-board diskette
		drive controller
IDE HDC	Enabled’	Enables the on-board hard disk
		drive controller
	Disabled	Disables the on-board hard disk
		drive controller
• Default setting

2 - 1 4 Running the SETUP Program